这是原厂说明的原文
Autotrim activates the automatic trim feature of your VBar Flybarless controller. If enabled,
the VBar will automatically trim the swash plate and the tail when the following conditions are met:
the motor must be running, collective must be in the range for hovering, and the cyclic and tail sticks must be left alone.
To perform a trim flight, bring the heli into a stable hover in front of you, then let it drift with no further stick inputs. If heli moves to far away, bring the heli back into a stable hover in front of you. After a few iterations you will notice that the heli will drift less and less, until it finally (almost) remains in the position you put it in.
To verify the quality of a trim flight, do a stationary pirouette: the heli should stay in place.
Now land and move the collective stick to 0° collective or slightly below, to prevent the autotrim function from continuing the trim process.
The learned values will be saved if you deactivate the auto trim feature, or if you cut power your VBar.
Note: Do a trim flight only in calm weather conditions. Wind will affect the quality of the trim flight.
Note: You can alter the trim values here to manually trim e. g. the tail center position, too. Swash plate trims should be done in the Heli Setup Wizard.
Note: Trim flight is a global parameter. You get the best results if you perform the trim flight at the rpm setting you mainly intend to use with a particular heli.
简单理解就是起飞后尽量少控制任它漂,漂远了拉回来,重复几次后就会稳住 |
/1 
发表于 2021-4-23 13:21
收藏
楼主
